3018 PRO Controller Mount

Got tired of the Fat-Finger-reach-around to turn unit on/off and fumbling with USB and power cable. So, I designed this to mount controller on top aluminum extrusion bar. will need 4 new m5x16 screws & Nuts to attach controller and will need to remove the top aluminum bar to slide mount into T slot. as you see in photo it complements the OfflineControl-stand-20-20 by AlexWimJan rather nicely, (Where I got the idea in first place).
There is a bit of post processing to do, removing all the supports but follow the print settings and print it on its side for best T-slot results. I also, increased the lip and back panel thickness from original for better strength. the lower nut inserts are tight, and the nut doesn't go completely in, just use a small Allan wrench to align the holes