Thingiverse
100mm duct connector
by chaosmoon
78
Downloads
63
Likes
0
Makes
A simple connector for the vacuum system i'm using with my workbee. The HBM 200 i bought came with 1 metre of flexible tubing. I purchased an additional 4 metres of pvc tubing which was less flexible. My solution was to use the flexible section connected to the KentCNC dustshoe and connect it to the overhanging pvc duct with this printed part. I was going to tie-wrap it, but the fit is tight enough without.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in