Hypercube Evolution Electronics Housing ( HUGE )

This is an alternative take on the electronics compartment of hypercube evolution printers.
It uses the back side of the printer to house all the electronics.

The voron electronics case is used as a base but completedly redesigned to fit a 300x300x400 HEVO.
Voron Electronics case : https://www.thingiverse.com/thing:2155152

This case can fit the following electronics:
- MKS Base Gen1.4
- Maxwell 5V PSU
- Raspberry Pi 3
- E3D Pt100 Amp board
- 2x AliExpress Mosfets
- PSU with 150mm