Thingiverse
42mm Stepper cooling duct for axial fan (40,50,60,70,80,92 mm)
by gibbon_
11
Downloads
5
Likes
0
Makes
This duct
* is narrow enough to fit on a 42x42x42mm stepper on the connector side (non-wide)
* has 1mm clearance on each end of the motor and a larger air vent (wide)
* holds a standard fan with the size of 40/50/60/70/80/92mm - fan height does not matter if you don't mind it sticking out a bit
* attachable with 2.9mm self-tapping screws (all models)
* attachable with some wire around the outside (through hole models)
* non-wide: 50-92mm
* wide: 60-92mm
* is attachable
* is narrow enough to fit on a 42x42x42mm stepper on the connector side (non-wide)
* has 1mm clearance on each end of the motor and a larger air vent (wide)
* holds a standard fan with the size of 40/50/60/70/80/92mm - fan height does not matter if you don't mind it sticking out a bit
* attachable with 2.9mm self-tapping screws (all models)
* attachable with some wire around the outside (through hole models)
* non-wide: 50-92mm
* wide: 60-92mm
* is attachable
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in