Thingiverse
Pokeball Plus Belt / Pant Case
by Filboyt
11
Downloads
20
Likes
1
Makes
Want to clip your Pokeball Plus to your hip By way of pants or belt? Here you Go!
Designed to use the wrist strap to hold the shell closed.
The gap between shells is so the Pokeball does not spin while in use, No need to get the
strap super tight and strain it.
Leave the finger ring below it as pictured.
Printed in .13 res using 10% Gyroid infill.
I used Line supports at 2mm only on the Shell, nothing else needs it.
Lines made removing pillar hole support much easier.
Just mirror t
Designed to use the wrist strap to hold the shell closed.
The gap between shells is so the Pokeball does not spin while in use, No need to get the
strap super tight and strain it.
Leave the finger ring below it as pictured.
Printed in .13 res using 10% Gyroid infill.
I used Line supports at 2mm only on the Shell, nothing else needs it.
Lines made removing pillar hole support much easier.
Just mirror t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in