Thingiverse
Box for electronics with KFB 2.0
by u-maker
11
Downloads
2
Likes
0
Makes
Box for electronics with KFB 2.0
Installation is assumed on one of the sidewalls.
The halves are connected with four screws M3x25 with nuts.
The board is mounted with M3x10 screws with nuts and washers.
The number of fans in the upper half is optional. Fastening - M3x16 screws with nuts and washers.
The necessary holes are drilled, cut, break out.
The height of the layer is 0.16 mm.
The nozzle is 0.4 mm.
The print speed is 50 mm / s.
Plastic - ABS.
Filling - 100%.
Installation is assumed on one of the sidewalls.
The halves are connected with four screws M3x25 with nuts.
The board is mounted with M3x10 screws with nuts and washers.
The number of fans in the upper half is optional. Fastening - M3x16 screws with nuts and washers.
The necessary holes are drilled, cut, break out.
The height of the layer is 0.16 mm.
The nozzle is 0.4 mm.
The print speed is 50 mm / s.
Plastic - ABS.
Filling - 100%.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in