Thingiverse
Prusa i3 MK3/MK3S Hotend Fan Cover/Grille (for black fan without rubber corners)
by Mr_Tantrum
51
Downloads
31
Likes
0
Makes
Finger/Fan protector for the black version of the Prusa i3 MK3 hotend fan (Noctua) without the rubber corners.
Made extra thin with bolt countersinks and corner standoffs for close fit.
FYI, I’ve discovered that having the fan cover installed causes the print to shift 3-4 mm to the right on the print bed. Under normal operation this is not an issue, but I recently needed to print something the full 250 mm width and it took me awhile to figure out why it was printing off the right side of
Made extra thin with bolt countersinks and corner standoffs for close fit.
FYI, I’ve discovered that having the fan cover installed causes the print to shift 3-4 mm to the right on the print bed. Under normal operation this is not an issue, but I recently needed to print something the full 250 mm width and it took me awhile to figure out why it was printing off the right side of
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in