Thingiverse
Ender 3 (Pro) - Raspberry Pi Model A+ Case for OctoPrint with Relay Control
by marvinda
186
Downloads
99
Likes
0
Makes
Disclaimer: I am not responsible for any damage you might cause, proceed at you own risk.
This design adds a case to your Ender 3 (Pro) that fits a Raspberry Pi 3 Model A+, a 10A relay (for switching LEDs on/off), a 30A relay (for switching printer on/off), a buck converter (for powering the Raspberry Pi from the Ender 3's PSU) and a 4010 fan. There is a hole in the lid to optionally fit the Pi Camera ribbon cable. This design was inspired by [giacomo30196](https://www.thingiverse.com/giacomo
This design adds a case to your Ender 3 (Pro) that fits a Raspberry Pi 3 Model A+, a 10A relay (for switching LEDs on/off), a 30A relay (for switching printer on/off), a buck converter (for powering the Raspberry Pi from the Ender 3's PSU) and a 4010 fan. There is a hole in the lid to optionally fit the Pi Camera ribbon cable. This design was inspired by [giacomo30196](https://www.thingiverse.com/giacomo
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in