Thingiverse
Calibration block using Calipers
by LeeR444
5
Downloads
1
Likes
0
Makes
This is work in progress.
Fusion 360 Their top and slicer top is different, fixed.
Trimmed down the Z , XYZ to XY for faster printing.
After printing several printing cubes and getting ambiguous results I made a part that I can verify X, Y, Z and E (filament width). The total width of a object (cube) is width + Extrusion error. I decided to make a differential measurement to take the E out of the equation.
To check XYZ: The way I check (There are many ways) I zero the caliper on the
Fusion 360 Their top and slicer top is different, fixed.
Trimmed down the Z , XYZ to XY for faster printing.
After printing several printing cubes and getting ambiguous results I made a part that I can verify X, Y, Z and E (filament width). The total width of a object (cube) is width + Extrusion error. I decided to make a differential measurement to take the E out of the equation.
To check XYZ: The way I check (There are many ways) I zero the caliper on the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in