Extruder PCB Mount

This is for the Monoprice IIIP+ extruder head assembly. It is just an easier and lighter mount for the PCB on the head. you will need 2x 3M 10mm long, 2x 3M nuts that measure 5.5mm wide and 2.5mm tall (I think this is the standard size), and the 2 little plastic washers used on the original mount, and 2x 4M at least 12mm long.

I glued the plastic washers to the face the board mounts too. You also need to press fit the 3M nuts into the printed part, you can use the screw to pull it into the ho