Slicer Discord
毽子 – 3D-Druckmodell von Thingiverse Thingiverse

毽子

5 Downloads
4 Likes
0 Makes
Zum Modell
Can't remove an obscene comment from a troll, so I deleted the earlier post and re-upload again without an English title.

This 毽子 is a traditional Chinese exercise/game, mainly played by kids and it is played the same way as kicking a hacky sack. There are many ways of making it and the materials used can range from feathers, papers to plastics, etc. I like the feather, because it looks nicer. The base was made a bit larger, so that my kids can hit it easier. The total weight in general is 5~15g and some competition ones are over 20g. For the beginners or kids, the lighter the better, because it will drop down at a slower speed with enough feathers. The downside for that is it requires more effort to kick it higher. The feathers are delicate, so try to pick up from the straw stem or the base to avoid damages. The print time is very minimum, less than 30 minutes.

Materials
Feathers(fits 4~8 feathers, Got 14g for $2 at the Michaels, but most craft stores should have it)
Straw(ID
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen