Thingiverse
R9 T Antenna TBS Source One
by Phr0z3n
7
Downloads
6
Likes
0
Makes
FrSky R9 T-Antenna mount for TBS SourceOne frame (v0.2, 5inch).
I use small zip ties to hold down components to the arms. The zip tie strip cutout, 3.75mm in width. Overall part is 17.506mm Length, 17.30mm Width, 12.25mm height (not including the two tabs that should sit against the arm, add an extra 2mm for overall high)
I found the best printing direction is with the "back" (without the hole flat) on the bed. I am running this print at 15mm/s, 230°, no retraction, and cooling for minima
I use small zip ties to hold down components to the arms. The zip tie strip cutout, 3.75mm in width. Overall part is 17.506mm Length, 17.30mm Width, 12.25mm height (not including the two tabs that should sit against the arm, add an extra 2mm for overall high)
I found the best printing direction is with the "back" (without the hole flat) on the bed. I am running this print at 15mm/s, 230°, no retraction, and cooling for minima
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in