Thingiverse
Gcode for bedleveling Anycubic 4MAX
by Coat
21
Downloads
15
Likes
0
Makes
Two simple, adjustable and short procedures in Gcode for manual bedleveling. Setting the bed is annoying enough, this makes it all a little bit easier I hope.
The codes do not print anything, only intended to adjust the bed. Start a code the same as you start a print.
Initially written for my Tevo Tornado. But the Gcode is adjusted for the Anycubic 4MAX. It is most probably also suitable for the Ender 3 and clones without touchscreen. Just check the short and easy to understand Gcode.
The
The codes do not print anything, only intended to adjust the bed. Start a code the same as you start a print.
Initially written for my Tevo Tornado. But the Gcode is adjusted for the Anycubic 4MAX. It is most probably also suitable for the Ender 3 and clones without touchscreen. Just check the short and easy to understand Gcode.
The
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in