Thingiverse
RC Airboat
by CDeviant
71
Downloads
65
Likes
0
Makes
This model is very water resistant, very buoyant, and goes pretty fast with my setup
I printed this on my Ender 3. The model is split for easier printing, or a single part if your printer can handle the height.
The hatch is 26mm deep, 150mm wide, 132mm long. It fits a 3c 2200mah lipo battery with plenty of room.
04/17/2019
Slight changes to body, major changes to hatch. Much more water resistant now. Add a little grease between the hatch/cap and it's practically waterproof if you've
I printed this on my Ender 3. The model is split for easier printing, or a single part if your printer can handle the height.
The hatch is 26mm deep, 150mm wide, 132mm long. It fits a 3c 2200mah lipo battery with plenty of room.
04/17/2019
Slight changes to body, major changes to hatch. Much more water resistant now. Add a little grease between the hatch/cap and it's practically waterproof if you've
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in