Thingiverse
Seed Sprouter Tray
by kendel3d
141
Downloads
107
Likes
0
Makes
These are sprout trays and a tray extension for the 4-Tray Seed Sprouter by VICTORIO as seen on Amazon.
This was printed in PETG plastic with a 1mm nozzle, a 0.5mm layer height and two perimeter walls. This makes the wall thickness about 2.4mm thick, so it is very strong. I printed 5 bottom layers to make it 2.5mm thick and 0 top layers with 0% infill to make it hollow. If you want an extension instead of the tray, just print with 0 bottom layers like the top and you will have an exten
This was printed in PETG plastic with a 1mm nozzle, a 0.5mm layer height and two perimeter walls. This makes the wall thickness about 2.4mm thick, so it is very strong. I printed 5 bottom layers to make it 2.5mm thick and 0 top layers with 0% infill to make it hollow. If you want an extension instead of the tray, just print with 0 bottom layers like the top and you will have an exten
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in