Thingiverse
Extendable funnel for vase mode
by TommyUnreal
69
Downloads
48
Likes
0
Makes
# Extendable funnel for vase mode
This is project of self-watering flower pot printable in vase mode (single outline or spiralize).
To print this, you are going to need wide nozzle, I used 0.8mm, which is sufficient. Wider nozzle will make the pot more sturdy, with this one it holds just fine. If you need flower pot for outdoor use, I strongly recommend to print this project with UV resistant filament like ASA.
Print "tip" part once and "hat" part once. The funnel is 13cm wide and 37 c
This is project of self-watering flower pot printable in vase mode (single outline or spiralize).
To print this, you are going to need wide nozzle, I used 0.8mm, which is sufficient. Wider nozzle will make the pot more sturdy, with this one it holds just fine. If you need flower pot for outdoor use, I strongly recommend to print this project with UV resistant filament like ASA.
Print "tip" part once and "hat" part once. The funnel is 13cm wide and 37 c
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in