Thingiverse
Hawk 5 gopro session mount
by Clausgudum
3
Downloads
4
Likes
0
Makes
Gopro session mount. 30 degrees tilt. Easy to mount. Good protection of the camera.
I use it for race-videos so it need to be solid. Because it mounts under the carbon sidepeaces, the screw holes does not rip open when it crashes.
Print in TPU. I printed it out lying on the side, with support set to "every where".
Enjoy
(I have been using https://www.thingiverse.com/thing:2957126 earlier on, and also used this as an inspiration to this design)
I use it for race-videos so it need to be solid. Because it mounts under the carbon sidepeaces, the screw holes does not rip open when it crashes.
Print in TPU. I printed it out lying on the side, with support set to "every where".
Enjoy
(I have been using https://www.thingiverse.com/thing:2957126 earlier on, and also used this as an inspiration to this design)
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in