Thingiverse
Ender 3 - Filament holder DELUXE Bushing for 5/16"x6" Bolt
by tee_jay37
6
Downloads
0
Likes
0
Makes
This is a modification to the Ender 3 - Filament holder DELUXE that requires less hardware.
Original Design:
https://www.thingiverse.com/thing:3114139/files
You will need:
1) 5/16"x6" Bolt
1) 5/16" Nylock Nut
2) 1/4" Washers (yes, 1/4")
The washers go inside the bushing, then the bushing goes inside the pockets which the bearings would normally go into. The washers are very close to the size of the bolt, so it should ride smoothly, for a fraction of the price of 2 bearings.
On
Original Design:
https://www.thingiverse.com/thing:3114139/files
You will need:
1) 5/16"x6" Bolt
1) 5/16" Nylock Nut
2) 1/4" Washers (yes, 1/4")
The washers go inside the bushing, then the bushing goes inside the pockets which the bearings would normally go into. The washers are very close to the size of the bolt, so it should ride smoothly, for a fraction of the price of 2 bearings.
On
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in