Thingiverse
Atomic Pi Flush (new) Baby Breakout Board Case
by WinsDesigns
68
Downloads
24
Likes
5
Makes
The new baby breakout board case is here! This fits an atomic pi and requires 3 M3x30 machine screws. The case requires no supports and prints in about 5 hours. This is a very snug fit and all ports are accessible. Enjoy!
If you need this printed, check out my etsy! use the code "THINGIVERSE" for an extra 20% off!
https://www.etsy.com/listing/732726821/flush-new-baby-breakout-board-case-for?ref=shop_home_active_1
Thingiverse isn't showing the photos properly, so here's an imgur link to
If you need this printed, check out my etsy! use the code "THINGIVERSE" for an extra 20% off!
https://www.etsy.com/listing/732726821/flush-new-baby-breakout-board-case-for?ref=shop_home_active_1
Thingiverse isn't showing the photos properly, so here's an imgur link to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in