Gazelle Power Supply Batter Charger Enclosure
by Daniel_1990
2
Downloads
3
Likes
0
Makes
The AC-Cable-plug of the battery charger was broken, therefore I soldered the cable directly on the connection pins on the PCB.
The enclosure is not watertight and even not protected against splash water.
Disclaimer: You alone are responsible for the changes on electronics and its equipment/enviorment. Working on PCBs should only be executed by trained persons.
To fixate the base part and cap, you could use the snap-function. Anyway, I suggest to also attach 2x M3 screws for better fixa
The enclosure is not watertight and even not protected against splash water.
Disclaimer: You alone are responsible for the changes on electronics and its equipment/enviorment. Working on PCBs should only be executed by trained persons.
To fixate the base part and cap, you could use the snap-function. Anyway, I suggest to also attach 2x M3 screws for better fixa
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in