Thingiverse
3D Printable Model Rocket
von Nick_Huff
10
Downloads
7
Likes
0
Makes
Fully 3D Printable Model Rocket nicknamed the SS Anne
This rocket was developed to see just how high I could get a rocket using a B6 series engine. This rocket is designed to go close to 500 feet high using a B6-6 engine from Estes.
It is however a WiP so I will be updating it as I finalize the design.
Rocket Statistics:
Apogee: 149m (489 feet)
Flight Time: 21 sec
Time to Apogee: 5.57 sec
Max Velocity: 58.3 m/s (130 mph)
Length: 29.2 cm (11.50 in)
Diameter: 2.4 cm (0.945 in)
Mass (w/ engine): 64.7 g
Engine: Estes B6-6
All rocket statistics came from OpenRocket
This rocket was developed to see just how high I could get a rocket using a B6 series engine. This rocket is designed to go close to 500 feet high using a B6-6 engine from Estes.
It is however a WiP so I will be updating it as I finalize the design.
Rocket Statistics:
Apogee: 149m (489 feet)
Flight Time: 21 sec
Time to Apogee: 5.57 sec
Max Velocity: 58.3 m/s (130 mph)
Length: 29.2 cm (11.50 in)
Diameter: 2.4 cm (0.945 in)
Mass (w/ engine): 64.7 g
Engine: Estes B6-6
All rocket statistics came from OpenRocket
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
