Thingiverse
3d Printer micro loop test!
von Pilot-Error
0
Downloads
0
Likes
0
Makes
Just a short test of flow and coasting settings using four single loops.
This was printed on an Ender 3v2 Neo on both a carbon fibre PEO and textured PEI build plate.
Sliced with PrusaSlicer 2.9.0.
This was printed on an Ender 3v2 Neo on both a carbon fibre PEO and textured PEI build plate.
Sliced with PrusaSlicer 2.9.0.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!