Thingiverse

3D Printer Proximity Sensor Component Box

von neildonn

4 Downloads

3 Likes

0 Makes

After following Thomas Sanladerers (https://www.youtube.com/watch?v=EcGFLwj0pnA&t=610s) instructions how to use and wire an Inductive Proximity Switch LJ12A3-4-Z/BY Sensor Detection PNP to a RAMPS board I decided to create a box/case for the components.

As you can clearly see the two resistors (15k - left and 10k - right, are used). Please follow Toms instructions for wiring. You will need 6 m3 6mm bolts. Four inside and four outside.

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat