Thingiverse
RigidBot Filament Support
by tchotchke
98
Downloads
38
Likes
2
Makes
Slightly tweaked version of [RigidBot Extruder Support Spacer](http://www.thingiverse.com/thing:389143) by [Kebes22](http://www.thingiverse.com/kebes22/designs).
This version adds a small ridge under the extruder gear cutout to fill in the gap where the NinjaFlex was getting jammed between the gear and the support piece. If you use this part, the extruder gear needs to be aligned with the raised ridge of the support part.
Like the original part, you'll need two short M3 flathead mac
This version adds a small ridge under the extruder gear cutout to fill in the gap where the NinjaFlex was getting jammed between the gear and the support piece. If you use this part, the extruder gear needs to be aligned with the raised ridge of the support part.
Like the original part, you'll need two short M3 flathead mac
Sign in to leave a comment
Sign in