Thingiverse
450MT Switch Protector
door outie555
0
Downloads
1
Likes
0
Makes
Protects the ignition switch from being ripped off accidently. Slips over the existing stock block. Can be secured with two zip ties if you want, otherwise it will probably stay on without them unless you crash. 10 second job to install with out zip ties, 1 minute with zipties. No glue or disassembly required to install.
Print in PLA or PETG. Easier in PLA but will probably not last as long. Print with tree supports.
I'm also selling these on eBay in small qty as the PETG is hard to print.
If it helped, feel free to sub to the outie555 YouTube channel and watch a few videos on the 450MT.
Print in PLA or PETG. Easier in PLA but will probably not last as long. Print with tree supports.
I'm also selling these on eBay in small qty as the PETG is hard to print.
If it helped, feel free to sub to the outie555 YouTube channel and watch a few videos on the 450MT.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!