MakerWorld
Organizers
Zum Modell
5 stack container rack
17
Downloads
16
Likes
3
Makes
Just a simple way to store these Amersumer 2.6x1 inch containers for jewelry found on Amazon. No supports needed print with the back facing upward, use Gyroid infill at 5%. there will be a little bit of hanging print that can be knocked off after complete. i leave them there so that the containers "lock" into the rack. Thank you!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
