Thingiverse
58 mm Lens Cap
door Jasonr79
72
Downloads
59
Likes
3
Makes
This is a two piece 58mm lens cap. The two pieces can be printed at the same time. When they are finished they will snap together. When snapping them together I found it worked best if you snap diagonally. If you go in a circle, the last peg sometimes doesn't go in properly.
It should scale proportionally for larger and smaller sizes. I'll keep you posted about this.
It should scale proportionally for larger and smaller sizes. I'll keep you posted about this.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
