Camera Lens Cap 58mm

Both pieces need supports . It should take less than an hour and a half in total. For the settings keep reading, for the story skip down below. The assemble it make sure all supports are cleared and slide the end without the ridges under the overhangs, then squeeze the ring and do this for the other side.20% infill0.2-layer height for main piece 0.12-layer height for ringGyroid infill200 temp.sunlu PLA filament Supports: yesThe story:I recently got out some old camera supplies and I couldn't find one of the lens caps, then as I look on pintables for a replacement (spoiler, I couldn't find one) I noticed the replacement parts competition and thought, this would make a good replacement part. This cap not only works for a replacement part, but for customization as well. Pretty much all camera lenses are black so it's fun to spice them up every once in a while. (I include a ”smile“ cap for fun) 19 test prints later I got a working model. Both are made out of PLA because it mimi