Thingiverse
K8200 & 3drag Bowden Filament guide
by turbotommi
20
Downloads
13
Likes
0
Makes
* Problem: The heavy filament coil is mounted much higer than the center of mass of the printer. This reinforces vibrations on higher speeds.
* Solution: I have mounted the coil on the table below Printer and use a PTFE bowden of 1m. In the files section you find the adaptor for original extruder and a holder for the construction profile.
The Bowden I have bought on Alibaba: http://www.aliexpress.com/item/3D-printer-nozzle-guide-tube-3D-Teflon-PTFE-tube-1-m-long-with-two-push/2030076428.
* Solution: I have mounted the coil on the table below Printer and use a PTFE bowden of 1m. In the files section you find the adaptor for original extruder and a holder for the construction profile.
The Bowden I have bought on Alibaba: http://www.aliexpress.com/item/3D-printer-nozzle-guide-tube-3D-Teflon-PTFE-tube-1-m-long-with-two-push/2030076428.
Sign in to leave a comment
Sign in