Free Pets STL Download - Cat / Dog Food + Water Dispensersby PhunXter

*NEWEST* *Updated to Vers 5.0 *Altered the angle of the dispensing chute and opening, plus rounded all the internal angles to reduce blockages *Reduced the amount of polygons to print a little quicker *Reduced the amount of supports needed. If your printer will print 58deg or higher you may not need supports at all *NEWER* *Updated to Vers.3.5 *Altered the bowl radius too allow more biscuits in the bowl at any one time *NEW* *Updated Food dispenser Vers.2.6 is much larger so that our furry friends can get their heads nearer to the bowl + It is better for dogs too, being a bit larger *I have made a reduction ring for this feeder to take 65mm jars that are more common in europe to fit the bowls 60mm fitting. ----- ----- ----- ----- ----- ----- ----- ----- ----- ----- ----- ----- ----- ----- ----- The white bowl in the photos is for water using a 300ml/500ml drinks bottle. I remixed this water dispenser from https://www.thingiverse.com/thing:38224. I smoothed out the original pointy end so my cat could get to the bottom of the bowl a bit easier as as she doesn't like using deep bowls (fussy cat) I used supports for this as the base of the bowl has a large cut-out and the fillet in the top-side is a bit risky without any support, You could probably get away without any if your printer bridges really good. * Also included the cat-drinkpond-tower.stl, and Water bowl-Fish_MkV.stl these are for adding bottles of water to your existing cats / dogs bowl. Just screw it to a 300ml/500ml bottle and turn it upside down, no more things are needed to let your furry friend have enough water for a couple of days * P.S. My 3 cats love it