Makerfarm Rear Mounted Spool Holder

This is a spool holder that replaces the left and right side of a Makerfarm i3V 8" LCD mount to allow a spool of filament to be held behind the printer. This design was created to reduce the over amount of space the printer takes up and to place the spool closer to the printer's center of gravity.

Right now, the spoke it the right length for the thinner (57mm wide) spool from Makerfarm.

Hardware needed:
(4x) M3x16 Bolt
(4x) M3 Nut

*UPDATE 1/8/17*
I uploaded a long spool