Thingiverse
7" LCD Case
von myrlyn
15
Downloads
7
Likes
0
Makes
Enclosure for Alomejor 7 inch LCD TFT Display 1024600 HDMI VGA Monitor Screen Kit for Raspberry Pi 3/2
https://www.amazon.com/gp/product/B07VSG29J2/ref=ppx_yo_dt_b_search_asin_image?ie=UTF8&psc=1
Should be compatible with Adafruit HDMI 4 Pi: 7" Display w/Touchscreen 1024x600- HDMI/VGA/NTSC/PAL
https://www.adafruit.com/product/2395?gclid=Cj0KCQiAwP3yBRCkARIsAABGiPr2Or1cprkWZ27yYXpXtvu1ugCaxPgARkVbYPazKBYN1yRDgTtoKkEaAmbaEALw_wcB
(LCD the same size, and uses same board) - however there is no cabling access for the touchscreen driver, and the fit for this has not been tested.
Assemble with 6 m3 hex-head screws, no nuts - screws thread directly into the plastic on the back part, and self-tap. You will need to use some force, but this worked fine in PETG.
https://www.amazon.com/gp/product/B07VSG29J2/ref=ppx_yo_dt_b_search_asin_image?ie=UTF8&psc=1
Should be compatible with Adafruit HDMI 4 Pi: 7" Display w/Touchscreen 1024x600- HDMI/VGA/NTSC/PAL
https://www.adafruit.com/product/2395?gclid=Cj0KCQiAwP3yBRCkARIsAABGiPr2Or1cprkWZ27yYXpXtvu1ugCaxPgARkVbYPazKBYN1yRDgTtoKkEaAmbaEALw_wcB
(LCD the same size, and uses same board) - however there is no cabling access for the touchscreen driver, and the fit for this has not been tested.
Assemble with 6 m3 hex-head screws, no nuts - screws thread directly into the plastic on the back part, and self-tap. You will need to use some force, but this worked fine in PETG.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!