3mm directdrive extruder - HD -Bowden - special mounting or flat

*Please note = this thing was an experiment , I have since changed to something else,
so this thing is basically discontinued. You are welcome to try it modify it or whatnot.

Direct drive bowden extruder:

- 3mm filiment
- bowden mount
- i3 plywood mount at back on sloped brace
- uses common 608 bearing
- will need 12-13mm 8mm smoothrod piece to mount the bearing
- fits nema 17 stepper motor
- will need the hobbed fitting for the stepper motor for 3mm
- 6x 3mm bolt