Thingiverse
KIS extruder - direct drive Nema 17 & Mk8 for 1.75 filament
by Phil_Maddox
320
Downloads
211
Likes
2
Makes
KIS-(Keep It Simple) Mk1 extruder for 1.75 filament
Using ideas from all over the net i have developed a simple adjustable tension DD extruder based on a Nema 17 & Mk8 filament drive bush.
The push fit for bowden tubes is based on the items supplied by E3D with their V6 kit.
The fitting sits in a 10mm dia hole 10mm deep and once in place a 2mm drill is used to drill through the printed holes and drill the sides of the push fit fitting. Following which 2 short lenghts of 1.75 filament
Using ideas from all over the net i have developed a simple adjustable tension DD extruder based on a Nema 17 & Mk8 filament drive bush.
The push fit for bowden tubes is based on the items supplied by E3D with their V6 kit.
The fitting sits in a 10mm dia hole 10mm deep and once in place a 2mm drill is used to drill through the printed holes and drill the sides of the push fit fitting. Following which 2 short lenghts of 1.75 filament
Sign in to leave a comment
Sign in