8BitDo SN30 Controller Holder

Simple controller holder for an 8BitDo SN30. Can be printed using any two colors.Variant that holds 2 controllers here: https://makerworld.com/en/models/575630#profileId-496064Important print profile info: There are two separate profiles here, one with the support for PLA material and one without. If you have the support for PLA material, I recommend using it even though it will take about 5 minutes to remove. It creates a little bit of a cleaner print. If you do not have it, I also have a profile that does not use it but uses tree supports on the build plate only that are easy to remove. It will create some small blemishes on the back of the base plate, but these will not be visible in use.