Thingiverse
Lulzbot TAZ bearing / bushing holders with tightening clamps
14
Downloads
8
Likes
0
Makes
Standard TAZ bearing holders, with an addition for clamping them around the IGUS bushings.
The IGUS bushings have a tendency to wear or become loose, allowing for play in the axes. Hopefully this will be a simple solution to this problem. I have not tested this part as of yet, but it seems to work. I'll post results when I do print + test it.
To use these clamps, you'll need m3 screws that are greater 12mm in length. You'll also need m3 nuts for the m3 screws.
For each double bearing
The IGUS bushings have a tendency to wear or become loose, allowing for play in the axes. Hopefully this will be a simple solution to this problem. I have not tested this part as of yet, but it seems to work. I'll post results when I do print + test it.
To use these clamps, you'll need m3 screws that are greater 12mm in length. You'll also need m3 nuts for the m3 screws.
For each double bearing
Sign in to leave a comment
Sign in