Thingiverse
A Flat Rectangle
door SeaTex
8
Downloads
6
Likes
0
Makes
***TPU/FLEX Highly Recommended***
This is simple. Prints simple too.
Glue, tape, screw, attach how you want, to the gunwale (outer topsides) of the bow of the boat, in sections side by side - to prevent the little splashing from the front of the boat making it’s way to the folks inside the boat.. Made for my small v-hull 12ft Jon boat.
(I have no 3d modeling skills so any requests to modify/remix sadly can't happen on my end.)
In Cura, or similar Slicers, you can adjust the dimensions of the part easily to suit your needs.
Default Dimensions : W/200 x L/100 x H/4mm (Mount Width-wise along vertical gunwale so shorter side is out and covers more gunwale)
2 side by side prints fit nicely on a 220x220x250 Creality Ender 3v2 Bed.
(My key settings (150% Wall Flow) (50% TriHex infill) (Lines for walls) (2 top/bottom Walls)
This is simple. Prints simple too.
Glue, tape, screw, attach how you want, to the gunwale (outer topsides) of the bow of the boat, in sections side by side - to prevent the little splashing from the front of the boat making it’s way to the folks inside the boat.. Made for my small v-hull 12ft Jon boat.
(I have no 3d modeling skills so any requests to modify/remix sadly can't happen on my end.)
In Cura, or similar Slicers, you can adjust the dimensions of the part easily to suit your needs.
Default Dimensions : W/200 x L/100 x H/4mm (Mount Width-wise along vertical gunwale so shorter side is out and covers more gunwale)
2 side by side prints fit nicely on a 220x220x250 Creality Ender 3v2 Bed.
(My key settings (150% Wall Flow) (50% TriHex infill) (Lines for walls) (2 top/bottom Walls)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
