Accessible memo notes device

This device will always keep your memo notes on top, just add rubber bands :)

Printing:
For printing the flat surfaces, it doesn't matter which side you decide to print. All the shapes are designed with 45 degrees and don't need support.
The general part (Shell) needs to be put upside down to avoid support and get a perfect finishing.

We recommend printing the Lifting Surface with 60% Infill to avoid tip brake.
For the Shell and the Bottom Cover, 20% Infill will be enough.
2 mm layer thickness for all parts.
In the photos, we used print with PLA.

Assembly:
For assembly steps refer to the attached GIF.

Enjoy!