Thingiverse
Adimlab Leveling knobs
von 3DDesignLife
75
Downloads
53
Likes
2
Makes
This is a snap in knob for Adimlabs 3D printers/HC Maker7.
These knobs are simple to print with 2 perimeters and 10% infill, each one use 12 grams of filament.
There is no need to remove the existing knobs! These literally snap on top of the existing knobs and make leveling 10 times easier.
These knobs are simple to print with 2 perimeters and 10% infill, each one use 12 grams of filament.
There is no need to remove the existing knobs! These literally snap on top of the existing knobs and make leveling 10 times easier.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!