Thingiverse
Advanced Bed level
di Nagasuye
4
Download
4
Likes
0
Makes
Made this bed level print so it can better show the bed level and where on the bed it's sticking or not. The model is 200mm x 200mm x 1mm so scale as need for layer height (if printing at 0.28 layer height, scale z height by 2.8). To test the bed level, I have been raising the initial (only) layer height speed to 100 mm/s and setting the bed 10 degrees lower than what the first layer is normally printed at. Must have layer width set to >= 0.4mm.
Also ideal to print when changing the filament because it uses enough to purge the last colour.
The only difference between the normal and no-string model is that the normal one has a small line that connects to the line most slicers lay down (from [10, 20] to [10, 200]) so both can be removed at the same time.
Also ideal to print when changing the filament because it uses enough to purge the last colour.
The only difference between the normal and no-string model is that the normal one has a small line that connects to the line most slicers lay down (from [10, 20] to [10, 200]) so both can be removed at the same time.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
