MakerWorld
Physics & Astronomy
Go to Model
AIR PUCK
7
Downloads
2
Likes
3
Makes
This is an Air puck/hovercraft is used with a balloon to have fun with a low friction device. This takes only a few hours to print and needs only a balloon and a smooth surface. (I can get fifty 9" balloons for $1 at my local dollar store) Note: Be sure to get the flared-out section inside the balloon just above the neck. This will give best results. Also, I find it easiest to attach if I blow the balloon up the twist the end a few times to help seal the air while attaching. I went through a few versions of this with my daughter to achieve the best results. If you have any feedback, please let me know in the comments.
IversonAK also publishes on
21 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
