Alien Dab

Here's an alien I designed and posed. The uploaded file is scaled to be 200mm (7.87 inches) tall. I printed him at 100% and it turned out decently.

It took about 8 hours to print, printed in ABS with 10% infill, and sliced with Slic3r.

The photos will show surface banding and issues that were caused by my printer; these issues have been resolved and I may reprint him to get a better quality surface.

Lastly, as you might've noticed, the image showing his mouth printed terribly. This was my fault ... the supports I generated were not sufficient. Please learn from my mistake and ensure the supports you generate will support his mouth properly.

The feet / base is completely flat and the print should stand upright just fine, though it isn't perfectly stable.


*********************************************************************************************
If you end up printing this guy, please post a "Make", I'd love to see your prints :)
************************************