Thingiverse
Alien head pencil topper
von DaddyWazzy
39
Downloads
45
Likes
0
Makes
remixed from this model on Printables
https://www.printables.com/model/146983-alien-sculpture
Just a fantastic model by Rikrdoga. I remixed this for a pencil topper. Support will be needed for the face but they are minimal, put a support blocker inside, not needed there. You could try no supports, I have not.
This can be printed with .28 layers, that is how I printed most of them, some at .25 depending on the printer. Used 3, Prusa MK3S+, Kywoo Tycoon. Ender 3 Pro. .28 was used on the Ender.
https://www.printables.com/model/146983-alien-sculpture
Just a fantastic model by Rikrdoga. I remixed this for a pencil topper. Support will be needed for the face but they are minimal, put a support blocker inside, not needed there. You could try no supports, I have not.
This can be printed with .28 layers, that is how I printed most of them, some at .25 depending on the printer. Used 3, Prusa MK3S+, Kywoo Tycoon. Ender 3 Pro. .28 was used on the Ender.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
