Slicer Discord
Amazon Echo Retaining Ring – 3D-Druckmodell von Thingiverse Thingiverse

Amazon Echo Retaining Ring

von rkagerer
5 Downloads
3 Likes
0 Makes
Zum Modell
I set my original Amazon Echo on a small shelf against the wall, and created this retaining ring to keep it from falling over if someone bumps into it. The ring mounts to the wall.

I've included a bonus stencil which can be used to perfectly locate drilling holes.

You can screw the ring into the wall from the front, or optionally put nuts in the pockets and bolt it from behind (through the rear panel of the shelf, as I did).
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen