AMS 2 Pro Stacking racks

Because overengineered is underrated. Public service announcementsFirst, some warnings. This is not designed with frugality in mind. You will need a LOT of filament. I have limited (kind of) the external hardware, but bear in mind a 6-kilo fully loaded AMS at 40cm from a plastic pivot... well, physics. Think twice, print once. Seriously, think through the planning of this before printing, and test as you go. I have gone through about seven versions of this, iterating on the design as I went. That does not mean this is perfect; it means it prints well enough on my fleet of A1, P1, and H2 printers, meeting the tolerances and clearances I need. Tolerances are tight. You will need to be strong-willed with a few bits here and there, run them in before proper use. I used PLA matte black for everything for the aesthetic (I did a couple of bits in PLA tough+ as I iterated), but everything has held up so far. Will it hold up over time? I don't know. Will ASA/ABS hold up better, yep, absolut