AMS Riser V2 Buffer Relocation Bracket

This model involves relocating your AMS buffer to the back of your AMS Riser V2 with a bracket that fits in to the back slots. This may reduces filament change times and therefore save you time, especially on big multi-color prints. This time savings will vary depend on print time and number of color changes etc. It might also reduce strain on the motors. My default profile for the P1S my filament time changes are about 30 seconds. With my new custom profile my filament time changes for load is around 5-7 seconds, and unload 8-10 seconds. This might not seem like much until you are doing many color change prints. Here is an example I did, I made a print that was 55:22 and 19 color changes, after this mod the same print was 44:57, that's a 11:25 min an 25 sec faster, or 18.81% overall reduced print time. You can use whatever length of tubing you want between the AMS and the buffer, and the Buffer and printer. Just try not to make too sharp of bend. A nice gentle curve is what you wa