Thingiverse
Engineering
Zum Modell
Anemometer
3
Downloads
4
Likes
0
Makes
You will also need:
- 2x 604 ZZ bearings,
- M4 x 40 bolt,
- 2x M4 x 0.7 nuts
So far I tried to measure rotations with optical sensor but did not turn out well. I will try with reed switch in the future.
Note: I printed with supports (one of my first prints) but I think it could be printed without.
- 2x 604 ZZ bearings,
- M4 x 40 bolt,
- 2x M4 x 0.7 nuts
So far I tried to measure rotations with optical sensor but did not turn out well. I will try with reed switch in the future.
Note: I printed with supports (one of my first prints) but I think it could be printed without.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
