Thingiverse
Anemometer variation
von antoniofiol
10
Downloads
6
Likes
0
Makes
I "upgraded" two minor features of https://www.thingiverse.com/thing:2523343
1. Hole for sensor wires increased in size (made it rectangular for simplicity)
2. Internal cone slope increased to facilitate printability without support (original printed nearly perfect, but since I was editing, I adjusted this as well)
1. Hole for sensor wires increased in size (made it rectangular for simplicity)
2. Internal cone slope increased to facilitate printability without support (original printed nearly perfect, but since I was editing, I adjusted this as well)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
