Anet A8 Filament Sensor Bracket

I wanted to add a Filament sensor attached to the X carrage on my Anet A8. So I created a bracket to hold this sensor in place so that the filament route lined up: https://www.thingiverse.com/thing:2443425

I am also going to mixup the filament sensor so that it can hold a PTFE tube.

You will need a 2 x M3*8 screws and 2 X M3 nuts to compliment. To fix the bracket to the X carrage you can use the existing screws.

The filament sensor is connected to my Raspberry Pi running Octoprint.