Thingiverse
Anet a8 nut caps
by mathcanbefun
6
Downloads
9
Likes
0
Makes
Simple nut cap for Anet A8. Designed for the nuts on the threaded rod located on the front acrylic face plates. Beveled top edge
The nuts are about 18mm long with the hexagonal cutout being 15mm deep. It does not interfere with the bed in any way.
Printed with 3d solutech PLA. 15% "fast honeycomb" infill. Oriented with the logo up. Add supports to bolster the top as it is layed down. 0.2 resolution support pillars will be fine. Horizontal offset from parts (in support menu) can be 0.3 possibly lower. Grab the supports with pliers and twist, most likely it will come out in one piece.
2 top and bottom layers. 1 perimeter shell.
Logo is aligned flush with one side of the hexagonal bolt shape. If the bolts are not straight the logo will not be straight. Easy fix, even easier to just deal with it.
The nuts are about 18mm long with the hexagonal cutout being 15mm deep. It does not interfere with the bed in any way.
Printed with 3d solutech PLA. 15% "fast honeycomb" infill. Oriented with the logo up. Add supports to bolster the top as it is layed down. 0.2 resolution support pillars will be fine. Horizontal offset from parts (in support menu) can be 0.3 possibly lower. Grab the supports with pliers and twist, most likely it will come out in one piece.
2 top and bottom layers. 1 perimeter shell.
Logo is aligned flush with one side of the hexagonal bolt shape. If the bolts are not straight the logo will not be straight. Easy fix, even easier to just deal with it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
